How do I reset my FiTech to factory settings?

Posted by Alan MacDonald on

How do you reset all FiTech settings to factory setting?

How do I reset my FiTech EFI to factory settings?

Resetting to a stock calibration:

From the main menu go to the very bottom and select Write Cal To ECU. Once in this menu scroll down to the second to last selection, it should say Default v8 T195. Once on this file select it and it will download to 100 percent. After this is done it will revert to the main menu. Now go to Go EFI Initial Setup, then Engine Setup, now input all of the parameters that are needed for your application, making sure to save each one individually.

After you have entered your information and saved it go up and select Dash Board. Once in dashboard turn the ignition key off and wait for all the data to black out. Once this happens turn the ignition key to the on position and start the car.

How do you reset all FiTech settings to factory setting?

On the handheld do the following steps.

  • 1. Key on and connect to ECU
  • 2. Go to the bottom of the Main Menu
  • 3. Open WRITE CAL TO ECU
  • 4. Load the DEFAULT V8 file


How do I Reset Learn?

All Fitech EFI systems have learning procedures that the system uses to adjust the active fuel tables it is using for operation. Sometimes if there are outside problems such as bad misfires, exhaust leaks, or any other situation that could cause poor readings on the O2 sensor, the system will try to compensate in order to keep the car running. If this happens it alters the fuel map in ways that may not be optimal for proper running the engine normally.

To reset the learn is a very easy procedure. Go into the Go EFI Initial setup then find Reset Learn. Once in that menu find Reset All Learn, highlight this and push right on the joy stick to go to #1, then save that to the ECU by pressing IN on the joystick. Once that is saved go back to the main menu, and then up to Dashboard and select it. Once on dashboard turn the key off and wait for the numbers in the value side to go black. This mean the system has saved. You have now reset the learn function.



Share this post

← Older Post Newer Post →