No lights on the AFM/DFM Disabler module?

Posted by Robert McJannett on

No lights on the module? Check the fuse.

Once in a while we run across a vehicle that has no power to the OBD2 port, which means our module cannot power up. This is usually due to the OBD2 fuse being blown and in most GM products this is shared with the CIG LTR fuse (not to be confused with the AUX PWR fuse, which is the other sockets).

This fuse is usually located under the hood in the fuse box and labeled as CIG, CIG/LTR or CIG/OBD. An example of a typical Silverado fuse box is shown above.

Your OWNERS MANUAL should have a diagram of your fuse box layout and the fuse positions/labels in the MAINTENANCE section. The OBD related fuse is normally located in the "in-cab" fusebox under the driver's side knee bolster OR in the side of the dashboard as you open the driver's side door.

 

 

What is the difference between the colours?

Nothing. It is purely decorative, there is no functional difference. When it is plugged in it will light up your footwell. In our opinion the Red model is the least annoying on the eyes. Some people have put electrical tape over it.

 

 

Range Technology AFM/DFM Disabler for GM Vehicles in Canada from Performance Improvements

The AFM/DFM Disabler is inexpensive and requires no time or effort by the owner to be installed. There is no learning curve or homework required.

Plug in the device, wait for the LED’s to power on, start your vehicle and drive.

It’s truly a plug and play resolution to potentially very costly repairs.

 


Other AFM Disabler Articles


Share this post



← Older Post Newer Post →